You'll need T-1 (3mm) LEDs, the same type for all keys. If you use different types, color/brightness will likely be uneven. Make sure to get LEDs without a flange. (The flange is a tiny, circular rim that encircles the bottom part of the LED's lens, right where the lens meets the base of the LED. This rim is slightly wider than the rest of the LED body, sticking out and not allowing the LEDs to sit flush with the key switch, resulting in increased height and the inability to press the keycaps fully.)

As for the keycaps, although there are compatible keycap sets, we don't know any backlight-friendly keycap set with south-facing symbols. But even if the keycaps are not backlight-friendly, the illumination between them can be satisfying to watch.

Original product text: If you can solder, you can add backlight to your UHK 60 v1 with this kit, which contains LEDs, backlight-friendly, laser-etched ABS keycaps, and a keycap puller. The kit contains keycaps for both ANSI and ISO UHKs, and it doesn't contain Mac and Windows keys, only Super keys.

See the installation instructions.

These screws are compatible with both the UHK 60 v1 and UHK 60 v2 palm rest.

If you need spare screws but don't want to pay shipping, this screw can be replaced with a standard M4 screw, with a maximum thread length of 7mm.

• 4 rubber feet for your UHK 60 v1. These rubber feet have the protruding bottom part seen in the picture.
• 4 additional rubber feet for your UHK 60 v2 and UHK 80. These rubber feet don't have the protruding bottom part seen in the picture.

You can fix them on your UHK with super glue.

4 feet for your UHK, including 4 bases, 4 legs, and 12 screws.

Please note that these feet are included with your UHK. You should only need to use the additional feet if you lose some.

This item is only compatible with the UHK 60 v1 and UHK 60 v1 Palm Rest. If you have a UHK 60 v2 or UHK 60 v2 Palm Rest then buy UHK 60 v2 Feet.

This item is only compatible with the UHK 60 v1. If you have a UHK 60 v2 then purchase a UHK 60 v2 case.